Leica Geosystems - Incident Mapping Suite
Knowledgebase
Use Align between Drawings to Combine data in Two Scenes
Posted by James Johnston on 26 January 2018 04:49 PM

Sometimes a scene can be measured by more than one instrument or teams of investigators to save time.  While it is possible to share common points or have the second team resect to the first crew's points, sometimes time does not allow for these careful steps to take place.  If this occurs, it's best to simply have the two teams of investigators complete a map of their section of the scene and combine the results in the drawing later on.

 

It's important to note that the evidence log and Measurement log will only show half of the measurements after this procedure is followed, so keep both original documents in case they are required for exhibit.

 

See the attached document for steps to perform an "Alignment between drawings" in Leiica Geosystems IMS Map 360:



Attachments 
 
 align between drawings.pdf (583.15 KB)
(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: