Leica Geosystems - Incident Mapping Suite
GS14 to Mesa 2 Using Data Collector Internet
Posted by Olivia Floyd on 10 February 2022 09:14 AM

The following was successful using GS14 Firmware 6.0.0. This is currently the only known supported firmware.

Part 1: Pair the GS14 using Windows Bluetooth Options:

1) Add a Bluetooth device to the Windows Bluetooth Options

2) Allow the Mesa2 to search for the GS14 via Bluetooth devices

3) Pair the device

4) Enter the code of 0000

5) Ensure the GS14 is visable under Connected Devices

6) Open Devices and Printers

7) Ensure the status is "Paired"

8) Ad hoc network

Part 2: Setting up EVR

1) Run EVR

- Open a project (Use a local Coordinate System)

2) Choose Leica and GS14 and the Bluetooth Port (A search is required for the first connection but never again). Press Connect.

3) Configure as below and then pick "Setup"

4) Source Type and Reference Network will vary. NTRIP Caster is used in this example. IP Address and Port Number provided by your Caster.

5) Pick Connect

6) Select a previous mountpoint, or request source table and select another mountpoint. Consult with you caster provider for information on the best Mountpoint to select

7) Wait for an RTK Fixed solution and look in the Observations toolbar for “live” lat/long values.

(0 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name: